Witam. Mam taki problem, mianowicie dziś rano mój 2,5 tdi afb nie odpalił. Pojawił się następujący błąd: 00546- Data wiring faulty 49-10- No communications- Intermittent
Czy ma on wpływ na problem z odpaleniem?
2,5 tdi afb nie odpalił po nocy
-
- Forum Audi A6 / A7
- Posty: 337
- Rejestracja: 18 paź 2011, 21:12
- Imię: Daniel
- Moje auto: A6 C5
- Rocznik: 1999
- Nadwozie: Limuzyna
- Silnik: 2.5TDI AEL 140KM
- Napęd: FWD
- Skrzynia: Manual
- Paliwo: Diesel
- Lokalizacja: Biecz
Instrukcja dotycząca błędu :
0546 - Data Wiring faulty: Implausible Signal
Possible Symptoms
Engine not starting / immediate Shutdown
Malfunction Indicator Light (MIL) ON
Possible Causes
Wiring and/or Connector(s) from/to Immobilizer Control Module (J362) faulty
No Signal or Implausible Signal on W-Line between Immobilizer Control Module (J362) and Engine Control Unit or Fuel Cut-Off Valve Control Unit
Immobilizer Control Module (J362) incorrectly coded
Immobilizer Control Module (J362) faulty
Possible Solutions
Check Wiring and/or Connector(s) from/to Immobilizer Control Module (J362)
Check Immobilizer Control Module (J362) Coding, Baud Rate Setting
Check/Replace Immobilizer Control Module (J362)
Special Notes
Under certain circumstances this code may be stored after improperly operating the Vehicle/Ignition. For example after the Engine has stopped the Ignition is switched on again immediately (Engine Control Module is still in the Start-Up Phase).
In such a case switch off the Ignition and wait at least 10 seconds before switching it back on. Then check and clear Fault Codes.
0546 - Data Wiring faulty: Implausible Signal
Possible Symptoms
Engine not starting / immediate Shutdown
Malfunction Indicator Light (MIL) ON
Possible Causes
Wiring and/or Connector(s) from/to Immobilizer Control Module (J362) faulty
No Signal or Implausible Signal on W-Line between Immobilizer Control Module (J362) and Engine Control Unit or Fuel Cut-Off Valve Control Unit
Immobilizer Control Module (J362) incorrectly coded
Immobilizer Control Module (J362) faulty
Possible Solutions
Check Wiring and/or Connector(s) from/to Immobilizer Control Module (J362)
Check Immobilizer Control Module (J362) Coding, Baud Rate Setting
Check/Replace Immobilizer Control Module (J362)
Special Notes
Under certain circumstances this code may be stored after improperly operating the Vehicle/Ignition. For example after the Engine has stopped the Ignition is switched on again immediately (Engine Control Module is still in the Start-Up Phase).
In such a case switch off the Ignition and wait at least 10 seconds before switching it back on. Then check and clear Fault Codes.
AUDI - Przewaga dzięki technice